What’s Included:

Each kit includes a 47in x 144in sheet of premium vinyl film—sized to wrap most side-by-sides and utility terrain vehicles (UTVs). Choose from matte, satin, or gloss finishes for a bold or stealthy style that matches your riding needs.

Recommended Tools:

• Metro Restyling Eco Glide Suede Squeegee: The best tool for achieving a smooth, scratch-free application on UTV surfaces—especially around soft plastics and curves.

• Metro Restyling Inferno Heat Gun: An industrial-grade heat gun with precise temperature control, perfect for shaping vinyl on contours.

• Metro Restyling Premium Pro Precision Knife (30°) + OLFA 30° Replacement Blades: For clean, accurate trimming around doors, corners, and fender flares.

• Metro Restyling Anti-Static Wrap Gloves: Reduces static and keeps the vinyl surface clean during application.

• 3M Finish Line Knifeless Tape: Ideal for safely cutting clean lines around complex areas without using a blade.

Pre-Installation Preparation:

1. Clean All Surfaces Thoroughly:

   • Wash plastics and metal surfaces to remove all dust, oils, or trail grime.

   • Wipe down with 70% isopropyl alcohol to remove remaining contaminants.

   • Clean inside door frames, air intakes, and trim edges carefully.

2. Remove Panels If Possible:

   • Disassemble doors, side panels, bumpers, and roofs when accessible to wrap off the vehicle for the cleanest results.

Installation Instructions:

1. Dry Fit the Vinyl:

• Before peeling, lay the vinyl over each section to plan material usage.

• For best results, start with larger panels like doors or front hoods.

2. Apply with Control:

• Tape the top edge of your panel and begin peeling the backing slowly.

• Use the Eco Glide Suede Squeegee to gently smooth the film from center outward—its suede edge glides across the surface with zero risk of scratches.

3. Tackle Contours & Curves:

• Warm the vinyl using the Inferno Heat Gun on a low setting to stretch around fenders, guards, or recessed panels.

• Avoid overstretching—lift and reposition as needed.

• Use relief cuts for compound curves or creases, overlapping vinyl slightly by ¼ inch.

4. Trim Smartly:

• Use the Precision Knife with fresh OLFA blades to trim edges and seams cleanly.

• For intricate areas like vents or door frames, use 3M Finish Line Knifeless Tape to avoid paint contact.

5. Final Touches:

• Lightly reheat and apply pressure to all wrapped surfaces to seal the adhesive.

• Let the wrap cure 24 hours before riding or washing.

Maintenance Tips by Finish:

Matte:

• Avoid waxes or polishes—use matte-safe cleaners only.

• Clean after muddy rides to prevent surface discoloration.

• Dry with microfiber towels to avoid streaks.

Satin:

• Use non-gloss detail sprays.

• Wipe in straight strokes, not circular, to preserve sheen.

• Avoid abrasive cleaning materials.

Gloss:

• Hand wash only; avoid automatic or high-pressure washes.

• Use vinyl-safe waxes or detail sprays for UV protection.

• Clean frequently to prevent water spots and surface buildup.